Detailed Contents
Preface
1 Microsoft Language Utilities
2 Board Installation
3 Operating System Setup
4 Installing Software
5 Configuration Utility
6 Setting up the Video Tape Recorder
7 Other Software
8 Other Hardware
After the PC/AT has been rebooted you are ready to
install the DigImage software. Place distribution disk one
in A:
(or B:)
drive and change to that drive. Type INSTALL
to start the installation procedure. Insert the appropriately
labelled disk when prompted by the installation program. After
all the files have been copied and (under Windows 95/98) the various
shortcuts have been created, the DigImage configuration utility
will be run automatically. This utility is the subject of the
next section.
DigImage documentation page
DigImage home page
Stuart Dalziel's home page